Industrial bitumen 85/25 - KN code: 27132000

General Features

Building bitumens produced by Hexán Ltd. fully satisfy the limit values specified in the test methods of conventional bitumens on the one hand, and increase the durableness of the roofing felts made of it on the other hand.These products are the row material of water-proofing, water-proofing felts and roofing felts.

Building bitumens produced by Hexán Ltd. fully satisfies all requirements.

  • Satisfy the limit values specified in the test methods of conventional bitumens (see MSZ EN Standard 13304:2003).
  • Ensure for the roofing felts made with their use to posses the warm-side and cold-side properties specified for roofing felts.
  • Guarantee appropriate resistance against aging.

Range of products: EB 85/25

Sales Information

Standard No.: MSZ EN 13304:2003

The properties of bitumen is basically determined by the forming material, which is petroleum. The quality of bitumen is determined by its components: paraffins, asphalt resin, oil and the amount of asphaltenes in crude oil. The density of the bitumen ranges from 950 to 1300 kg/m3 (25 ° Cos temperature). Black shiny fracture, low melting material. Due to continuous heating it becomes soft, flexible and finally becomes liquid. However, after cooling solidifies again.

  • The rock particles will be involved well
  • It has good adhesion property
  • Wide temperature range usability
  • At low temperature it is non-rigid, not prone to cracking
  • It does not suffer structural changes at the temperature of the asphalt production temperatures. Properly heat resistant.

Utilization:

  • Building insulation
  • Insulation board production
  • Bituminous filler and patches production. The clay-like material is mixed with different fillers (rock flour, shredded mineral fibers, etc.) The resulting easy to spread bituminous mass is used for sealing of cracks, sealing joints, corners, etc

Emergency overview:

  • Hazard
  • The solid bitumens have no environmental or health effects
  • Care must be taken about water-free quality of bitumen because the water gets foamed in hot bitumen, what would cause danger of scalding
  • Hot bitumento induce skin can causes burns. Wearing personal protective equipment is recommended.
  • In case of fire must not be put out with water.
  • These materials are flammable therefore extinguishing materials (sand, fire-extinguisher), prohibition signs shall be place

Packaging: barrel (62 kg)

Please use the form below to contact us with any questions, suggestions or comments you may have.


References

  • Richter Gedeon
  • Sanofi
  • Reanal Labor
  • Suzuki
  • Mol Group